A home that is texture coated will be able to have a weather shield that will protect it from the rain, sun, heat and mildew; thus, lengthening the exterior's life. The texture coat is helpful in keeping your home's external temperature lower which would mean savings on the electrical bill. While the process can be time consuming, it is just easy to perform and it takes just some planning for days.
Inspect your Home's Exterior
This is necessary so that you can check for damaged areas. While the texture coat offers protection, this cannot help a damaged area. Take note of such areas.
Dig a Trench
The trench should be located at your home's exterior. Such trench must reach around one foot away from your home and must have a minimum depth of 6 inches. If your home's siding extends over 6 inches, your trench must be about 3 inches below your siding's bottom.
Wash Your Home Thoroughly
Your home must be pressure washed with the use of a water solution and mild detergent. Ensure that you remove loose paint, dirt, mildew, mold and other contaminant.
Repair Damaged Areas
Use similar substrate which is presently in place in repairing any damaged areas. When your home is wood, the surface should be repaired with wood; if it's siding, you can make use of siding in repairing the damaged areas. Keep in mind that the look of the final coat can be compromised by altering your materials.
Cover Surrounding Landscaping
You can use huge drop cloths in protecting the plants. Put the plastic sheets over your windows and doors while you secure the plastic using painter's tape. This can protect the decorative and glass parts of your home.
Spray the Texture Coating Primer
You can start with a coat of the primer material on your home's exterior. The material is quite thick so you must make an adjustment to the power sprayer until you will be able to obtain the desired coverage. Make use of a piece of plywood in spraying the primer until you get the desired outcomes. The texture coating primer must be sprayed evenly across the house's surface through a wide sweeping motion so that you can avoid excess texture in some house spots and light textures in others. Let the primer dry for a couple of hours.
Apply the Texture Coating Material
This type of coating should be applied over the primer in order to provide further protection. Again, make sure that you adjust the power sprayer in spraying the right amount. In applying the coating material, utilize short and even strokes to get uniform effect. Let the material dry for a couple of hours.
Paint your Home's Trim Areas
You can do this using a protective outdoor paint that coordinates or matches with your texture coating. Let the paint dry for 4 hours and take away the plastic sheeting from your windows and doors and then uncover your landscaping.
Visit Wall Coatings Leeds office near you to learn more effective ways of coating the walls of your house.
Article Source: http://EzineArticles.com/?expert=Jessie_Reyes
Essential Guide in Texture Coating Your Home
