A reclining sofa is a furniture composed of a nonreclining center piece and a couple of reclining chairs. While solid sofas can be reupholstered through a slip cover, a reclining sofa needs more steps that include disassembly. When you have enough time to do a reverse engineering of your sofa, you can certainly reupholster it and enjoy a fresh-looking sofa. Here are some steps to help you carry out this project.
Disassemble the Sofa
With the majority of models, you can see the pieces attached with screws or bolts so it is important to prepare a screwdriver and wrench.
Turn Each Piece Over
If you can find a batting or fabric that covers the bottom of the pieces, take the staples or nails away using your hammer's nail remover.
Pull the Fabric Off the Pieces
While doing this, you need to be careful with big tears. If you cannot get the fabric come off easily, you can make use of the nail remover that you can find at the back of a hammer so that you can pull the nails or staples out while you hold the fabric in place.
Mark the Piece you have Taken Off
You can use a chalk to do the markings. This will help you determine where the pieces will attach. Make sure that your marking is specific to the position of the pieces on the sofa and the order where you took it from.
Disassemble the Seam Pieces
Using a seam ripper, start disassembling the pieces at the seams. Do not tear the fabric to ensure that you can view the seam allowance clearly. Again, make use of chalk in marking the connection of each piece.
Lay the Old Fabric on Top of the New Fabric
Do this on your pin board then pin the two pieces together. Trace your old piece into your new one. All the pieces should be cut out using sharp sewing scissors.
Remove Old Padding from from the Frame of the Couch
After this, you can trace the shapes into your new padding. Usually, the padding is glued lightly into the wood frame and you can pull this up easily. Pick any foam pieces off from the frame.
Spray Upholstery Adhesive
Spray the adhesive to the new padding's back sides and then secure the sides to the wood frame.
Pin and Sew the Fabric Pieces
While following the directions of the old chalk, you can do the sewing. You can carry out double stitching to the seams and utilize an upholstery thread to provide more thread.
Lay the Fabric on Top of the Padding and Frames
It is likely for the fabric to look smaller on your pieces due to your new padding. You can just stretch and staple your fabric to your frame while you make sure that you have the same tension allowance as the old fabric. Finally, you can assemble the sofa again.
For more high quality reupholstery services, please visit reupholstery keighley office near you.
Article Source: http://EzineArticles.com/?expert=Jessie_Reyes
