In terms of painting, old walls can introduce some issues. The issue can become complicated because of poorly patched holes, uneven surfaces, ridges from wallpaper and old adhesive or old layers of a lead-based paint. Unless you have a plan to install new sheet rock, it is not likely for you to obtain a surface which appears brand new. However, with good surface preparation and the right tool, it is always possible to provide old walls a clean and fresh look which has character and texture.
Cover Furniture, Rugs and Floors with a Tarp
Spread the tarp to room stuffs that you cannot remove. Wall fixtures, outlet plates and switch should be unscrewed and removed. You have the option to tape them off using a painter's tape if you don't like to remove them. Also, you need to take away nails, hangers and screws.
Use a Vinyl Spackle to Path Holes, Depressions and Dents
The vinyl spackle should dry quickly and expand as well as contract with your wall. You can spread the spackle thinly on a putty knife and then draw it over the surface while you gently press it. Let it dry for around one hour.
Lightly Sand Spackle Areas
This is necessary so that you can feather the patches' edges flush with your wall. Sand down ridges and bumps. The wall can be vacuumed using a soft brush as an attachment to eliminate particles from sanding.
Apply the Primer
Paint four-inch strips of primer along ceilings windows, corners and door frames as well as baseboard edges using a trim brush. This is helpful in preventing you from touching woodwork as you use the paint roller. After you are done, use warm water in washing the brush and set this aside to dry. Roll your paint roller until you coat the whole surface. Roll it over your walls using crossing and smoothing strokes. Smaller depressions found in the sealing and old wall can be filled by the primer covering stains and old paint. Allow the primer coat to dry totally for 4 hours.
Apply the Flat Paint
The flat paint will help you achieve a matte finish. Use the trim brush in cutting in edges covering the primer in an even manner. Use another paint roller as you apply the paint. Cover you walls as you did when you applied the primer coat. Allow the flat paint to dry for six to eight hours or until your paint is completely dry to touch. If necessary, apply another coat.
For more effective ways of coating the walls of your house and rendering, you may visit Exterior Rendering Leeds office near you.
Article Source: http://EzineArticles.com/?expert=Jessie_Reyes
Valuable Guide in Painting Old Walls
